WEG CFW501 V1.8X Programming Manual page 94

V V W Vector Control
Seq Action/Indication on the Display
13
If necessary, modify the content of P0407 – Motor rated
„
power factor, or press the
14
At this point, the HMI shows the option to do the Self-Tuning.
„
Whenever possible, execute the self-tuning. To activate the
self-tuning, change the value of P0408 to 1.
15
During the self-tuning, the HMI will simultaneously indicate
„
the "RUN" and "CONF" status. And the bar indicates the
operation progress.
10
10-10 | CFW501
Seq
18
key for the next parameter.
19
Figure 10.2: Start-up of the V V W mode
Action/Indication on the Display
To exit the STARTUP menu, just press BACK/ESC.
„
By means of the and
„
menu or press BACK/ESC again to return directly to the
HMI monitoring mode.
keys, select the desired