WEG CFW501 V1.8X Programming Manual page 93

For better visualization of the start-up in the V V W mode, check
10-10, below.
Seq Action/Indication on the Display
1
Monitoring mode.
„
Press the ENTER/MENU key to enter the 1
„
programming mode.
2
The PARAM group is selected; press the
„
until selecting the STARTUP group.
3
When the STARTUP group is selected, press the
„
ENTER/MENU key.
4
Press ENTER/MENU and with the
„
set the value 3, which activates V V W control mode.
5
Press ENTER/MENU to save the modification of P0202.
„
11
If necessary, modify the content of P0403 – Motor rated
„
frequency, or press the
12
If necessary, modify the content of P0404 – Motor rated
„
power, or press the
level of the
st
or key
and keys
key for the next parameter.
key for the next parameter.
Figure 10.2: Start-up of the VVW mode on page
Seq Action/Indication on the Display
6
Press the key to proceed with the Startup of the V V W.
„
7
If necessary, modify the content of P0399 – Motor rated
„
efficiency, or press the
8
If necessary, modify the content of P0400 – Motor rated voltage
„
or press the key for the next parameter.
9
If necessary, modify the content of P0401 – Motor rated
„
current, or press the
10
If necessary, modify the content of P0402 – Motor rated
„
speed, or press the
16
At the end of the Self-Tuning. The values of P0408
„
automatically return to "0", as well as the "RUN" and
"CONF" status are erased.
Press the key for the next parameter.
„
17
The result of the Self-Tuning is the value in ohms of the stator
„
resistance shown in P0409. This is the last parameter of
the Self-Tuning of the VVW control mode. Pressing the
key returns to the initial parameter P0202.
V V W Vector Control
key for the next parameter.
key for the next parameter.
key for the next parameter.
CFW501 | 10-9
10