Analog Outputs - WEG CFW501 V1.8X Programming Manual

12.2 ANALOG OUTPUTS

The analog outputs (AOx) are configured by means of three types of parameters: function, gain and signal, as per
block diagram of Figure 12.3: Block diagram of Analog outputs – AOx on page
Function
AO1 – P0251
AO2 – P0254
P0001
P0002
P0003
P0011
P0009
SoftPLC
P0037
P0696
P0697
P0698
(*) Control terminals available in the Plug-In module.
P0014 – Analog Output AO1 Value
P0015 – Analog Output AO2 Value
Adjustable 0.0 to 100.0 %
Range:
Properties: ro
Access groups I/O, READ
via HMI:
Description:
Those read-only parameters indicate the value of the analog outputs AO1 and AO2 in percentage of the full
scale. The indicated values are those obtained after the multiplication by the gain. Check the description of
parameters P0251 to P0256.
Gain
AO1 – P0252
AO2 – P0255
Figure 12.3: Block diagram of Analog outputs – AOx
Digital and Analog Inputs and Outputs
12-7.
AO1 – P0014
AO2 – P0015
Signal
AO1 – P0253
AO2 – P0256
Value AOx
AO1
(*)
AO2
(*)
Factory
Setting:
12
CFW501 | 12-7