WEG CFW501 V1.8X Programming Manual page 150

Parâmetros de Leitura
P0005 – Output Frequency (Motor)
Adjustable
Range:
Properties:
Access groups
via HMI:
Description:
Real frequency instantly applied to the motor in Hertz (Hz).
P0006 – Inverter Status
Adjustable
Range:
Properties:
Access groups
via HMI:
Description:
It indicates one of the ten possible inverter status. In
description of each status is presented, as well as the indication on the HMI.
P0006
0
1
2
3
4
15
5
6
7...9
15-2 | CFW501
0.0 to 500.0 Hz
ro
READ
According to Table 15.1: Inverter status - P0006 on page 15-2
ro
READ
Table 15.1: Inverter status - P0006
Status HMI
Ready
Run
Sub
Fault
Fxxxx
Self-Tuning
(conf RUN)
Configuration
(conf)
DC Braking
(RUN)
Reserved
Table 15.1: Inverter status - P0006 on page
Indicates the inverter is ready to be enabled.
Indicates the inverter is enabled.
Indicates the voltage in the inverter is too low for
operation (undervoltage), and will not accept the
enabling command.
Indicates the inverter is in the fault status.
Indicates the inverter is executing the Self-Tuning
routine.
Indicates the inverter has incompatible parameter
programming. Refer to
CONFIG STATUS on page
Indicates the inverter is applying DC braking to stop
the motor.
-
Factory
Setting:
Factory
Setting:
15-2, a
Description
section 5.7 SITUATIONS FOR
5-12.
-