WEG CFW501 V1.8X Programming Manual page 45

P0200 – Password
Adjustable 0 = Inactive
Range: 1 = Active
1 to 9999 = New Password
Properties:
Access groups HMI
via HMI:
Description:
It allows activating the password (by inserting a new value) or disabling it. For further details regarding the use
of this parameter, refer to Table 5.2: Required procedure for each kind of action on page
Action
1. Set P0200 with the desired value for the password (P0200 = password);
Activate password 2. After this procedure, the new password is active and P0200 is automatically adjusted for 1 (password
1. Set the current value of the password (P0000 = password);
2. Set the desired value for the new password in P0200 (P0200 = new password);
Change password
3. After this procedure, the new password is active and P0200 is automatically adjusted for 1 (password
1. Set the current value of the password (P0000 = password);
Disable password 2. Set inactive password (P0200 = 0);
3. After this procedure, the password is disabled
1. Activate a factory default by means of P0204;
Disable password
2. After this procedure, the password is disabled
Notes:
(1) It only allows changing the content of the parameters when P0000 is equal to the value of the password.
(2) It is allowed to change the content of the parameters and P0000 is inaccessible.
P0205 – Main Display Parameter Selection
P0206 – Secondary Display Parameter Selection
Adjustable
0 to 1079
Range:
Properties:
Access groups HMI
via HMI:
Description:
These parameters define which parameters are shown on the HMI display in the monitoring mode.
More details of this programming can be found in
MONITORING MODE on page
Basic Instructions for Programming and Settings
Table 5.2: Required procedure for each kind of action
active) .
(1)
active) .
(1)
section 5.6 SETTING OF DISPLAY INDICATIONS IN THE
5-12.
Factory
Setting:
Procedure
.
(2)
.
(2)
Factory
Setting:
0 = Inactive
5-3.
P0205 = 2
P0206 = 1
CFW501 | 5-3
5