Indications On The Hmi Display - WEG CFW501 V1.8X Programming Manual

HMI and Basic Programming

4.2 INDICATIONS ON THE HMI DISPLAY

The information shown on the HMI LCD display is divided into five fields: menu, status, secondary display, unit,
and main display. Those fields are defined in
display set allows alternating the focus to scroll the parameter number or parameter value according to levels 2
and 3 of the parameterization mode, respectively.
Menu (to select the
4
parameter groups) –
only one parameter
group is shown at a
time.
Parameter groups available in the field Menu:
PARAM: all parameters.
„
READ: read only parameters.
„
MODIF: parameters modified in relation to the factory default.
„
BASIC: parameters for basic application.
„
MOTOR: parameters related to the motor control.
„
I/O: parameters related to digital and analog inputs and outputs.
„
NET: parameters related to the communication networks.
„
HMI: parameters to configure the HMI.
„
HVAC: parameters related to HVAC applications.
„
STARTUP: parameters for oriented Start-up.
„
Status of the inverter:
LOC: command source or local references.
„
REM: command source or remote references.
„
: direction of rotation by means of arrows.
„
CONF: CONFIG status active.
„
SUB: undervoltage.
„
RUN: execution.
„
4-2 | CFW501
Figure 4.2: Display areas on page
Local/Remote
(command
and reference
source)
Forward/Reverse
Main display
Figure 4.2: Display areas
4-2. The main and secondary
Inverter status
Secondary display
Unit of measurement
(it refers to the value
of the main display)