Removal And Reinstallation Of The Front Cover - Mitsubishi Electric MELSERVO-J4 Series Instruction Manual

Removal and reinstallation of the front cover

WARNING
• Before removing or installing the front cover, turn off the power and wait for 15 minutes or more until the charge lamp turns off. Then, confirm that the voltage
between P+ and N- is safe with a voltage tester and others. Otherwise, an electric shock may occur. In addition, when confirming whether the charge lamp is
off or not, always confirm it from the front of the servo amplifier.
The following shows how to remove and reinstall the front cover of MR-J4-700GF(-RJ) to MR-J4-22KGF(-RJ) and MR-J4-
500GF4(-RJ) to MR-J4-22KGF4(-RJ).
The diagram is for MR-J4-700GF-RJ.
Removal of the front cover
1) Hold the ends of lower side of the front cover with both hands.
3) Pull out the front cover to remove.
A)
A)
2) Pull up the cover, supporting at point A).
1 FUNCTIONS AND CONFIGURATION
1
57
1.7 Structure