Installation And Removal Of Mr-J3-T10 - Mitsubishi Electric MR-J4-*B-RJ010 Series Instruction Manual

1. FUNCTIONS AND CONFIGURATION

1.8 Installation and removal of MR-J3-T10

WARNING
CAUTION
Before installing or removing the CC-Link IE interface unit, turn off the power and
wait for 15 minutes or more until the charge lamp turns off. Then, confirm that the
voltage between P+ and N- is safe with a voltage tester and others. Otherwise, an
electric shock may occur. In addition, when confirming whether the charge lamp is
off or not, always confirm it from the front of the servo amplifier.
Avoid installing and removing MR-J3-T10 repeatedly. Any contact failure of the
connector may be caused.
Avoid unsealing MR-J3-T10 to be free of dust and dirt against the connector
except installing. Make sure to use the pre-packing when storing.
Avoid using MR-J3-T10 of which the hook and knobs for fixing are damaged. Any
contact failure of the connector may be caused.
When installing and removing MR-J3-T10 to the MR-J4-500B-RJ010 or more,
avoid dropping out the installing screw inside it. Otherwise, it may cause a
malfunction.
When installing MR-J3-T10 to the MR-J3-500B-RJ010 or more, avoid damaging
the control board by the fixing plate. Otherwise, it may cause a malfunction.
Make sure to tighten MR-J3-T10 with the enclosed installing screws when
installing.
POINT
The internal circuits of the servo amplifier and MR-J3-T10 may be damaged by
static electricity. Always take the following precautions.
Ground human body and work bench.
Do not touch the conductive areas, such as connector pins and electrical
parts, directly by hand.
1 - 28