POWER (MENU)
Programming Codes
See Also
Function Group
Menu Map 5
Description
Programming Codes
P-6 Operating and Programming Reference
SCPI:
NONE
Analyzer:
NONE
/
), (
ON
OFF
POWER
"Introducing the HP 8360 B-Series Swept Signal Generators" in
Chapter 1
"Getting Started Advanced" in Chapter 1
"Programming Typical Measurements" in Chapter 1
POWER
This softkey changes the mapping of absolute power parameters
on input to the swept signal generator. It does not change the RF
output produced by the swept signal generator. The equation used to
determine the displayed value is:
Entered or Displayed Power = Hardware Power (ALC) + Active Offset
POWer:OFFset:STATe ONlOFFlljO
POWer:OFFset <num>[DB](MAXimum~MINimum~UP(DOWN
Analyzer:
NONE
[
)
and POWER [MENU].
POWER
LEVEL
),
and (ON/OFF).
LEVEL