HP 8360 B Series User Manual page 346

A U T O
A U T O BUS
A U T O
Don't care
*RST state is AUTO.
LIST[:POWer]:CORRection (<num>CDB] lMAXimumlMINimum)l*801
l
l
Sets and queries the list of correction levels that correspond to each
of the frequencies entered using the
attenuator is not allowed to change during the list execution. The
number of parameters can be from
After *RST, the value is 0.
l
Returns the number of correction points that have been entered into
the list array. After *RST returns a
LIST:TRIGger:SOURce IMMediatelBUSIEXTernal
l
LIST:TRIGger:SOURce?
l
Sets and queries the list point-to-point trigger source when in the
automaticlistmode. See LIST:MODE and 1NIT:CONTfor more details.
*RST state is
l
l
Sets and queries the amplitude marker on/off switch. While [n] may
be used, there is really only a single switch for all the markers.
*RST value is OFF.
MARKer[n]:AMPLitude:VALue <num>[DBllMAXimumlMINimum
l
MARKer[n]:AMPLitude:VALue? [MAXimumlMINimum]
l
Sets and queries the value of the amplitude marker. While [n]
How
Each new frequency point is
stepped to automatically,
after waiting the specified
Wait for a <GET> or *TRG
advancing to the next
frequency in the list.
Wait for a signal to be
received on the external
input before advancing to
the next frequency in the
list.
Only the list point
specified by LIST:MANual
is played back.
LIST:FREQ command.
1 to 801.
1.
Operating and Programming Reference S-39
the list is played back.
The
may