l-40 Getting Started Advanced
GENERATOR
OENERRTOR
Creating Arbitrarily Spaced Frequency-Correction Pairs
in a Swept mm-wave Environment
For this example, refer to menu map 5, POWER.
1. The equipment setup shown in Figure l-20 assumes that
you have followed the steps necessary to correctly level the
configuration. If you have questions about external leveling, refer
to "Externally Leveling the Swept Signal Generator".
Setup Power Meter
2. Zero and calibrate the power meter/sensor.
3. Connect the power sensor to test port.
4. Enter and store in the power meter, the power sensor's cal factors
for correction frequencies to be used.
Figure l-20.
H P 437B
POUER METER
POUER SENSOR
H P 4378
POUER NETER