HP 8360 B Series User Manual page 454

System Connections
Note
The HP 8510 Network Analyzer
The HP 8360 B-Series swept signal generator is compatible with
any HP 8510 network analyzer with firmware revision 4.0 or higher.
To upgrade firmware for an existing HP 8510, an HP 11575C
Revision 4.0 Upgrade Kit or an HP 11575D Revision 5.0 Upgrade Kit
is required.
HP 8510 revisions prior
the following connections:
SWEEP OUTPUT
n
STOP SWEEP IN/OUT
n
AUXILIARY INTERFACE
n
HP 8510 revisions 6.0 and greater use the connections as designated
on the rear panel of the swept signal generator. They are:
TRIGGER OUTPUT
n
STOP SWEEP IN/OUT
n
HP-IB INTERFACE
n
AUXILIARY INTERFACE
n
The dedicated HP 8510 versions of the HP 8360 (HP 83621B,
HP 83631B) may b e configured to power-up to one of two possible
system languages, network analyzer language, or SCPI (Standard
Commands for Programmable Instruments). This configuration is
controlled via a switch located on the rear panel of the instrument.
The factory default setting for this switch is network analyzer
language at an HP-IB address of 19. To interface with a network
analyzer the language selected must be Analyzer language. Refer to
earlier paragraphs in this chapter for the rear panel switch settings.
Models other than the dedicated HP 8510 versions are set at the
factory for SCPI. To interface with a network analyzer the language
selected must be Analyzer language.
to (not inclusive)
6.0 require that you use
Installation 3-2 1