HP 8360 B Series User Manual page 368

Function Group
Menu Map
Description
Programming Codes
See Also
Function Group
Menu Map 2
Description
FREQUENCY
2
This hardkey lets you set a value for the frequency span in the center
frequency/frequency span mode of swept frequency operation. Press
signal generator sweeps from one half the span below to one half
above the center frequency.
Certain center frequency and frequency span combinations cause the
swept signal generator to limit the value entered. In general, any
combination that causes the swept signal generator to exceed its
minimum or maximum specified frequency is limited.
FREQuency:SPAN <num>[freq suffix] or
FREQuency:MODE SWEep
Analyzer:
DF <num> [Hz]Kz]Mz]Gz]
"Center Frequency/Span Operation" in Chapter 1
FREQUENCY
This hardkey activates swept frequency mode and makes the start
frequency parameter the active function. Press (START) and use the
entry area to enter the desired value. The start/stop frequency must
be separated by at least 2 Hz in order to remain in the frequency
sweep mode. If start=stop frequency then the zero span mode is
entered.
Operating and Programming Reference S-6 1