HP 8360 B Series User Manual page 434

CAUTION
Initial Inspection
This chapter provides installation instructions for the HP 8360
B-Series swept signal generator and its accessories. It also provides
information about initial inspection, damage claims, preparation for
use, packaging, storage, and shipment.
This product is designed for use in Installation Category II and
Pollution Degree 2 per IEC 1010 and 664, respectively.
Inspect the shipping container for damage. If the shipping container
or cushioning material is damaged, it should be kept until the
contents of the shipment have been checked for completeness and
the swept signal generator has been checked mechanically and
electrically. The contents of the shipment should agree with the
items noted on the packing slip. Procedures for checking the basic
operation of the swept signal generator are in Chapter 4, "Operator's
Check and Routine Maintenance". You will find procedures for
checking electrical performance in the "Performance Tests" chapter
HP 8360 B-Series Swept Signal Generator/HP 8360 L-Series
of your
Swept CW Generator Service Guide.
If there is any electrical or mechanical defect, or if the shipment is
incomplete, notify the nearest Hewlett-Packard office. If the shipping
container is damaged, or if the cushioning material shows signs of
stress, notify the carrier as well as the Hewlett-Packard office. Keep
the shipping material for the carrier's inspection. The HP office
will arrange for repair or replacement without waiting for a claim
settlement.
Installation 3-1