HP 8360 B Series User Manual page 477

Index-8
example program
flatness correction, l-103
HP-IB check, l-90
local lockout, 1-91
looping and synchronization, l-99
setting up a sweep, l-93
synchronous sweep, l-101
use of queries, 1-95
use of save/recall, l-97
example programs, l-87-105
examples, equipment used, l-2
examples, simple program messages, l-72
example, stimulus response program, l-77
extended numeric parameters
discussed in detail, 1-84
explained briefly, l-74
extenders
HP-IB, C-8
trigger source defined, 1-119
external ALC BNC, L-3, L-4
external ALC connector, C-5
external AM, A-16
external detector calibration, E-6
external detector leveling, L-3
external frequency standard, T-l
external leveling, l-23-29
coupling factor, C-12
detector calibration, E-6
low output, l-26
theory of, A-7
with detectors, couplers, or splitters, l-23-26
with power meters, l-27
with source modules, l-28
external power meter range, P-23
external pulse modulation, P-18
external trigger
frequency list, L-9
external trigger, stepped sweep, S-70
external trigger, sweep mode, S-63
F
factor, coupling, C-12
factory preset, P-10
factory-set interface addresses, 3-7
fan filter, clean, 4-5
fastest sweep-retrace cycle, S-62
fault information, F-l
fault information 1, F-2
fault information 2, F-3
fault menu, F-l
fault status
clear, C-2
feature status, D-6
filter