HP 8360 B Series User Manual page 495

Index-26
FM waveform, I-7
trigger
automatic, frequency list, L-8
stepped sweep automatic, S-69
stepped sweep external, S-70
sweep mode external, S-63
trigger commands
defined, 1-118
trigger functions
list mode, P-14
trigger, group execute command, S-17
TRIGGER (HP BASIC), 1-119
trigger input BNC, S-71
trigger input connector, C-6
trigger, interface bus
stepped sweep, S-70
trigger out delay, T-4
trigger output BNC, T-4
trigger output connector, C-6
trigger point
external, list mode, L-9
interface bus, list mode, L-8
trigger states
event detection, 1-112
idle, l-111
in general programming model, l-109
sequence operation, 1-114
trigger system
general programming model, l-109
TRIG configuration, 1-116
Trigger system
TRIG trigger configuration, 1-116
*TST?, S-17
two-tone control, S-64
typeface conventions, vii
U
uncoupled attenuator, A-7, U-l
unleveled message, l-10, 1-18
unlock, information on status, U-l
UNLVLD message, 1-18
UNLVLED message, l-10
during amplitude modulation, M-14
up arrow, A-21
user calibration functions, U-3
user-defined leveling, F-4
user defined menu, U-4
user defined menu erase, U-6
user defined softkey erase, U-5
user defined softkeys, A-22
user flatness array, l-33-46
frequency value, E-2
HP 437B, l-34