HP 8360 B Series User Manual page 348

Power Subsystem
measured and the absolute value of the peak percent deviation to be
returned.
MEASure:FM
l
A query-only command that causes the modulating FM signal level
to be measured and the corresponding peak frequency deviation
returned.
MODulation:OUTPut:SOURce AMIFM
l
MODulation:OUTPut:SOURce?
l
Sets and queries the source of the rear panel output modulation
BNC.
MODulation:OUTPut:STATe ONlOFFlllO
l
MODulation:OUTPut:STATe?
l
Sets and queries the state of the rear panel output modulation BNC.
MODulation:STATe?
l
Queries the status of any modulation. If any of the modulation states
are on, then it returns a 1, otherwise it returns a 0.
Any place where dBm is accepted as a suffix, any level suffix is
accepted also. In the absence of a suffix, the units are assumed to be
as set by the UNIT:POW command.
l
POWer:ALC:BANDwidth?I:BWIDth? CMAXimumlMINimuml
l
Sets and queries the ALC bandwidth. This is actually not
continuously variable, so the input is rounded to the nearest possible
*RST
switch position.
is ON.
POWer:ALC:BANDwidthl:BWIDth:AUTO ONlOFFlllO
l
POWer:ALC:BANDwidthl:BWIDth:AUTO?
l
Sets and queries the automatic ALC bandwidth selection switch. The
*RST value is
ON.
POWer:ALC:CFACtor <num>[DB] lMAXimumlMINimumlUPlDOWN
l
POWer:ALC:CFACtor? CMINimumlMAXimuml
l
Sets and queries the coupling factor used when the command
POWer:ALC:SOURce INTernallDIODelPMETerlMMHead
l
POWer:ALC:SOURce?
l
setting is automatically determined
Operating and Programming Reference S-41
since AUTO