HP 8360 B Series User Manual page 398

Introduction
WARNING
Front Panel Error
Messages in
This section lists the error messages that may be displayed by the
front panel or transmitted by the swept signal generator over the
interface bus. Each error message is accompanied by an explanation,
and suggestions are provided to help solve the problem. Where
applicable, references are given to related chapters of the user's and
service guides.
A list of the messages displayed on the message line of the swept
signal generator are included in separate list because they are
considered status messages rather than error messages.
No operator serviceable parts inside. Refer servicing to qualified
personnel. To prevent electrical shock, do not remove covers.
ABILITY TO SAVE A RECALL REGISTER IS LOCKED OUT:
This message occurs when the save/recall registers have been
disabled by the save lock feature or by a calibration constant.
ADDR ERROR EXCEPTION:
internal processor error. Refer to Chapter 4 for instructions on
contacting a qualified service technician.
Auto Track Failed! Cal Not Updated:
been initiated and for some reason has failed. Refer to Chapter 4 and
follow the local operator's check procedures.
BUS ERROR EXCEPTION:
internal processor error. Refer to Chapter 4 for instructions on
contacting a qualified service technician.
DEFAULTING LANGUAGE:
conjunction with one of the following messages.
Invalid Language set on rear panel switch.
n
switch located on the rear panel has been set to an invalid
programming language selection. The programming language is
defaulted to the previous setting. Check the rear panel switch.
See Chapter 3 for information on language selection.
This can only be caused by an
Occurs when auto track has
This can only be caused by an
This error message is displayed in
The HP-IB/Language
Error Messages 2a-1