HP 8360 B Series User Manual page 174

Function Group
Menu Map 2,s
Description
Programming Codes
See Also
FREQUENCY, POWER
This softkey is used in two locations: Fltness Menu and
List Menu.
Flatness Menu - When selected, the swept signal generator waits for
a numeric value representing the number of correction points to be
entered. --> Number of Correction Points: is displayed in the
active entry area. A list of frequencies containing the number of
specified points is created automatically. The list begins at the auto
fill start frequency and ends at the auto fill stop frequency. The rest
of the points are equally spaced between them. A minimum of two
points must be entered.
If the number of points requested creates a list that exceeds the
number of elements available (801), the following message appears:
TOO MANY CORRECTION PTS REQUESTED
List Menu - When selected, the swept signal generator waits for a
numeric value representing the number of list points to be entered.
entry area. A list of frequencies containing the number of specified
points is created automatically. The list begins at the auto fill start
frequency and ends at the auto fill stop frequency. The rest of the
points are equally spaced between them. A minimum of two points
must be entered.
If the number of points requested creates a list that exceeds the
number of points available (801), the following message appears:
Error. . . t o o m a n y l i s t p o i n t s r e q u e s t e d .
P o i n t s u s e d : 0
Points available : 801
SCPI:
NONE, see Fltness Menu or List Menu
Analyzer:
NONE
"Optimizing Swept Signal Generator Performance" in Chapter 1
Operating and Programming Reference A-25
Auto Fill #Pts