HP 8360 B Series User Manual page 286

Programming Codes
POWER (i+
Function Group
Menu Map 5
Description
SCPI:
Analyzer:
PL
Set Atten, Tracking Menu, Uncoupl Atten
"Programming Typical Measurements" in Chapter 1
POWER
This hardkey accesses the power function softkeys.
Fltness Menu
Power Offset
Power Slope
Power Sweep
Set Atten
Tracking Menu
Uncoupl Atten
All RF power functions except for power level, flatness on/off, and
RF on/off are contained in the power menu.
Cal Menu,
Accesses the softkeys in the flatness
correction menu.
Changes the displayed power to include
an offset, but does not change the
output power of the swept signal
generator.
Activates the linear, power-per-frequency
mode of power output, and makes RF
slope (dB/GHz) the active function.
Activates power sweep mode and makes
power sweep (dB/swp) the active
function.
Activates uncoupled attenuator as
the mode of operation
attenuator value the active function.
Accesses the softkeys in the tracking
calibration menu.
Uncouples the attenuator from the ALC
system.
Allows you to enter values for the power
level step size.
Operating and Programming Reference P-5
POWER (MENU_)
/ ),
ON OFF
and makes the