Table of Contents
Advertisement
Example
Keystrokes
1.
2
.
3 .
DC Offset
5-10 Parameters
The following example shows how to change the
amplitude to 2.309 Vrms (6.531 V(p-p))
The Parameter display is shown. "AMPL" is highlighted.
"2.309" is displayed.
The amplitude is accepted and "2.309 V RMS" is displayed.
The m (DC offset) key enables you to display the DC
offset of the output signal. To change this value, either
the relevent unit key; @ or [mvl. To enter a negative
offset, press (CHS) before entering the value.
The DC offset range is dependent upon amplitude and
the high-voltage option (if installed). See Table 5-4 for a
list of the DC offsets allowed.
Result
Advertisement
Table of Contents
