HP 8360 B Series User Manual page 343

S-36 Operating and Programming Reference
Sets and queries the CW frequency. This does not change the
See FREQ : CENTER
l
l
l
l
Sets and queries the
switch keeps the two functions coupled together when ON. Changing
one ofthem, changes both. *RST setting is OFF. See FREQ:CENTER
for more information.
FREQuency:MANual <num>[freq
l
FREQuency:MANual? [MAXimumlMINimuml
l
Sets and queries the
frequency in swept manual mode. The limits
information.
FREQuency:MODE FIXedlCWlSWEeplLIST
l
FREQuency:MODE?
l
Sets and queries the switch that selects either swept, CW or list
operation. *RST value is CW.
FREQuency:MULTiplier <num>lMAXimumlMINimum
l
FREQuency:MULTiplier? [MAXimumlMINimuml
l
Sets and queries the frequency multiplier. The numeric value is
rounded to the nearest integer. This function changes mapping of
frequency parameters on input to and output from the swept signal
generator. Changing this does not affect the output frequency of the
swept signal generator. Only the displayed parameters and query
responses are changed.
The equation implied by this is :
Entered/displayed frequency = (Hardware Freq * Multiplier ) + Offset
After *RST, the value is 1.
FREQuency:MULTiplier:STATe ONlOFFlllO
l
FREQuency:MULTiplier:STATe?
l
Queries and turns the frequency multiplier off and on.
After *RST, the setting is OFF.
FREQuency:OFFSet Cnum>lMAXimumlMINimum
l
FREQuency:OFFSet? [MAXimumlMINimuml
l
Sets and queries the frequency offset. This function changes the
for more information.
manual frequency. This controls the output
are START and STOP.