HP 8360 B Series User Manual page 494

sweep mode stepped frequency list, S-73
sweep once, S-59
sweep output connector, C-5
sweep span calibrate always, S-74
sweep span calibrate once, S-75
sweep span calibration, F-15
sweep time, l-10
sweep time coupled to stepped sweep, D-10
sweep time key, S-75
sweep time set automatically, S-76
swept offset measurement, S-66
swept operation
center frequency, C-l
swept power, 1-18
swept signal generator as controller, 3-7
swept signal generator, no front-panel change address, 3-8
swept signal generator remote address, A-l, E-l
swept signal generator reset command, S-15
swept signal generator status, D-6
switch, line, L-5
synchronization command, S-14
synchronization, example program, l-99
synchronous sweep, example program, l-101
synchronous sweep operation, interface bus, S-17
syntax diagrams
commands, 1-81
message terminators, l-80
program message, l-80
response message, l-82
syntax drawings, l-57
system controller on bus message, 2a-4
system interface connector, C-7
system language (SCPI), P-14
system menu keys, S-77
T
tab
proper use of, l-69
talker, definition of, l-56
temperature, operating, 3-9
terminators
program message, l-64, 1-81
program message:use in examples, l-64
response message, l-65
time, sweep set automatically, S-76
tmr conflct fail, F-4
track fail, F-2
tracking, l-49
tracking functions, T-3
transition filter, l-107
in general status register model, l-106
*TRG[trg], 1-119
triangle
AM waveform, I-4
Index-25