HP 8360 B Series User Manual page 369

Programming Codes
See Also
Function Group
Menu Map
Description
Programming Codes
See Also
S-62 Operating and Programming Reference
FREQuency:STARt <num>[freq suffix] or
FREQuency:MODE SWEep
Analyzer:
FA <num> [Hz]Kz]Mz]Gz]
"CW Operation and Start/Stop Frequency Sweep" in Chapter 1
"Programming Typical Measurements" in Chapter 1
MARKER
3
This softkey changes the swept signal generator start frequency
to the frequency value of marker
frequency value of marker 2. The swept signal generator has been
reset to these start/stop values, unlike the softkey
that changes the start/stop values only while active.
SCPI:
SWEep[:FREQuency]:MARKer:XFER
Analyzer:
SHMP
Sweep
"Marker Operation" in Chapter I
1, and the stop frequency to the
Ml--M2 Sweep