HP 8360 B Series User Manual page 344

mapping of the frequency parameters on input to and output from
the swept signal generator. Changing this does not affect the
output frequency of the swept signal generator. Only the displayed
parameters and query responses are changed. The equation implied
by this is :
Entered/displayed frequency = (Hardware Freq * Multiplier ) + Offset
After *RST, the value is 0.
FREQuency:OFFSet:STATe ONlOFFlllO
l
FREQuency:OFFSet:STATe?
l
Queries and turns the frequency offset off and on.
After *RST, the setting is OFF.
FREQuency:SPAN <num>[freq
l
FREQuency:SPAN? [MAXimumlMINimum~
l
Sets and queries the frequency span.
information.
FREQuency:STARt <num>[freq suffix]
l
FREQuency:STARt? CMAXimumlMINimuml
l
Sets and queries the START Frequency.
information. *RST setting is MIN.
FREQuency:STEP:AUTO ONlOFFlllO
l
FREQuency:STEP:AUTO?
l
Sets and queries the function switch that controls the calculation of
the frequency step size (FREQ:STEP:INCR). If the response is
AUTO ON, then the swept signal generator selects a step size that is
coupled to the frequency span. The *RST setting is
l
l
Sets and queries the frequency step size to use for any node in the
frequency subsystem that allows
this value explicitly causes a
The *RST setting is automatically calculated from span.
FREQuency:STOP <num>Cfreq
l
Sets and queries the stop Frequency. See
information. *RST setting is
See FREQ : CENTER for more
See FREQ : CENTER for more
UP and DOWN
FREQ:STEP:AUTO OFF command.
FREQ : CENTER for more
MAX.
Operating and Programming Reference S-37
ON.
as parameters. Setting