At+Cgact Activate Or Deactivate Pdp Context - Quectel EC25 Command Manual

<Source statistics descriptor> Integer type. Specifies characteristics of the source of the submitted
<Signalling indication>

10.7. AT+CGACT Activate or Deactivate PDP Context

The Write Command is used to activate or deactivate the specified PDP context(s). After the command
has been completed, the MT remains in V.250 command state. If any PDP context is already in the
requested state, the state for that context remains unchanged. If the MT is not PS attached when the
activation form of the command is executed, the MT first performs a PS attach and then attempts to
activate the specified contexts. If no <cid>s specify the activation/deactivation form of the command, it
will activate or deactivate all defined contexts.
AT+CGACT Activate or Deactivate PDP Context
Test Command
AT+CGACT=?
Read Command
AT+CGACT?
Write Command
AT+CGACT=<state>,<cid>
EC25&EC21_AT_Commands_Manual
all SDUs belonging to the UMTS bearer compared to the SDUs of
other bearers. If the parameter is set to „0‟ the subscribed value will be
requested (refer to 3GPP TS 24.008 subclause 10.5.6.5).
0 Subscribed
1
2
3
SDUs for a PDP context.
0 Characteristics of SDUs are unknown
1 Characteristics of SDUs corresponds to a speech source
Integer type. Indicates signaling content of submitted SDUs for a PDP
context.
0 PDP context is not optimized for signaling
1 PDP context is optimized for signaling
Response
+CGACT: (list of supported <state>s)
OK
Response
+CGACT: <cid>,<state>[<CR><LF>+CGACT: <cid>,<state
>...]
OK
Response
OK
NO CARRIER
If there is any error related to ME functionality:
+CME ERROR: <err>
LTE Module Series
EC25&EC21 AT Commands Manual
162 / 231