At+Qcfg="Urc/Ri/Ring" Ri Behavior When Ring Urc Is Presented - Quectel EC25 Command Manual

Parameter
<enable> 0
1

4.3.13. AT+QCFG="urc/ri/ring" RI Behavior When RING URC is Presented

AT+QCFG="urc/ri/ring", AT+QCFG="urc/ri/smsincoming" and AT+QCFG="urc/ri/other" control the
RI (ring indicator) behavior when a URC is reported. These configurations will be stored into NV
automatically. The ring indicator is active low. AT+QCFG="urc/ri/ring" specifies the RI behavior when
URC RING is presented to indicate an incoming call.
The sum of parameter <activeduration> and <inactiveduration> determines the interval time of "RING"
indications when a call is coming.
AT+QCFG="urc/ri/ring" RI Behavior When RING URC is Presented
Write Command
AT+QCFG="urc/ri/ring"[,<typeri>[,<pul
seduration>[,<activeduration>[,<inacti
veduration>[,<ringnodisturbing>]]]]]
Maximum Response Time
Parameter
<typeri>
EC25&EC21_AT_Commands_Manual
Refused to establish multi PDNs with the same APN profile
Allowed to establish multi PDNs with the same APN profile
Response
If
<inactiveduration> and <ringnodisturbing> are omitted,
return the current configuration:
+QCFG:
"urc/ri/ring",<typeri>,<pulseduration>,<activeduration>,
<inactiveduration>,<ringnodisturbing>,<pulsecount>
OK
If all configuration parameters are entered, set the RI
behavior when RING URC is presented:
OK
ERROR
If there is any error related to ME functionality:
+CME ERROR: <err>
300ms
RI behavior when URCs are presented
"off" No change. Ring indicator keeps inactive.
"pulse" Pulse. Pulse width determined by <pulseduration>.
"always" Change to active. RI behavior can be restored to inactive by
AT+QRIR.
EC25&EC21 AT Commands Manual
<typeri>, <pulseduration>,
LTE Module Series
<activeduration>,
50 / 231