At+Qideact Deactivate A Pdp Context - Quectel BG96 TCP/IP Application Note

Maximum Response Time
Characteristics
Parameter
<contextID>
<context_state>
<context_type>
<IP_address>

2.2.3. AT+QIDEACT Deactivate a PDP Context

The Write Command deactivates a specific context and close all TCP/IP connections set up in this context.
Depending on the network, it may take at most 40 seconds to return OK or ERROR after executing
AT+QIDEACT. Before the response is returned, other AT commands cannot be executed.
AT+QIDEACT Deactivate a PDP Context
Test Command
AT+QIDEACT=?
Write Command
AT+QIDEACT=<contextID>
Maximum Response Time
Characteristics
BG96_TCP/IP_Application_Note
If there is any error:
ERROR
150 s, determined by network.
/
Integer type. Context ID. Range: 1–16.
Integer type. Context state.
0 Deactivated
1 Activated
Integer type. Protocol type.
1 IPv4
2 IPv6
String type. The local IP address after the context is activated.
Response
+QIDEACT: (range of supported <contextID>s)
OK
Response
OK
If there is any error:
ERROR
40 s, determined by network.
/
LPWA Module Series
BG96 TCP/IP Application Note
13 / 52