At+Ipr Set Te-Ta Fixed Local Rate - Quectel EC25 Command Manual

2
3
NOTES
1. The command is applied for command state.
2. The <parity> field is ignored if the <format> field specifies no parity.

3.5. AT+IPR Set TE-TA Fixed Local Rate

The command is used to query and set the baud rate of the UART. The default baud rate value (<rate>) is
115200bps. The setting of <rate> will not be restored with AT&F.
AT+IPR Set TE-TA Fixed Local Rate
Test Command
AT+IPR=?
Read Command
AT+IPR?
Write Command
AT+IPR=<rate>
Maximum Response Time
Reference
V.25ter
Parameter
<rate> Baud rate per second
9600
19200
38400
57600
EC25&EC21_AT_Commands_Manual
Mark (1)
Space (0)
Response
+IPR: (list of supported auto detectable <rate>s),(list of
supported fixed-only <rate>s)
OK
Response
+IPR: <rate>
OK
Response
This parameter setting determines the data rate of the TA on
the serial interface. After the delivery of any result code
associated with the current command line, the rate of
command takes effect.
OK
300ms
LTE Module Series
EC25&EC21 AT Commands Manual
34 / 231