At+Crlp Select Radio Link Protocol Parameter - Quectel EC25 Command Manual

Example
AT+CRC=1
OK
+CRING: VOICE
ATH
OK
AT+CRC=0
OK
RING
ATH
OK

7.18. AT+CRLP Select Radio Link Protocol Parameter

The Write Command sets radio link protocol (RLP) parameters used when non-transparent data calls are
originated.
AT+CRLP Select Radio Link Protocol Parameter
Test Command
AT+CRLP=?
Read Command
AT+CRLP?
EC25&EC21_AT_Commands_Manual
//Enable extended format
//Indicate incoming call to the TE
//Disable extended format
//Indicate incoming call to the TE
Response
TA returns values supported. RLP (Radio Link Protocol)
versions 0 and 1 share the same parameter set. TA returns
only one line for this set (where <ver> is not presented).
+CRLP:
(list of supported <iws>s),(list of supported <mws>s),(list of
supported <T1>s),(list of supported <N2>s),<ver>
+CRLP:
(list of supported <iws>s),(list of supported <mws>s),(list of
supported <T1>s),(list of supported <N2>s),<ver>
+CRLP:
(list of supported <iws>s),(list of supported <mws>s),(list of
supported <T1>s),(list of supported <N2>s),<ver>
OK
Response
TA returns current settings for RLP version. RLP versions 0
and 1 share the same parameter set. TA returns only one line
for this set (where <ver> is not presented).
+CRLP: <iws>,<mws>,<T1>,<N2>,<ver>
+CRLP: <iws>,<mws>,<T1>,<N2>,<ver>
LTE Module Series
EC25&EC21 AT Commands Manual
105 / 231