2.12. AT&W Store Current Parameters to User Defined Profile
The command stores the current AT command settings to a user defined profile in non-volatile memory.
AT&W Store Current Parameters to User Defined Profile
Execution Command
AT&W[<n>]
Maximum Response Time
Reference
V.25ter
Parameter
<n>
0
2.13. ATZ Set all Current Parameters to User Defined Profile
The command restores the current AT command settings to the user defined profile in non-volatile
memory, if one was stored with AT&W before. Any additional AT command on the same command line
may be ignored.
ATZ Set all Current Parameters to User Defined Profile
Execution Command
ATZ[<value>]
Maximum Response Time
Reference
V.25ter
Parameter
<value>
0
EC25&EC21_AT_Commands_Manual
Response
TA stores the current parameter settings in the user defined
profile. See Table 9.
OK
300ms
Profile number to store current parameters
Response
TA sets all current parameters to the user defined profile. See
Table 10.
OK
300ms
Reset to profile number 0
LTE Module Series
EC25&EC21 AT Commands Manual
19 / 231