At+Cfun Set Phone Functionality - Quectel EC25 Command Manual

2.22. AT+CFUN Set Phone Functionality

The command controls the functionality level. It can also be used to reset the UE.
AT+CFUN Set Phone Functionality
Test Command
AT+CFUN=?
Read Command
AT+CFUN?
Write Command
AT+CFUN=<fun>[,<rst>]
Maximum Response Time
Reference
3GPP TS 27.007
Parameter
<fun> 0
1
4
<rst> 0
1
Example
AT+CFUN=0
OK
AT+COPS?
+COPS: 0
OK
AT+CPIN?
EC25&EC21_AT_Commands_Manual
Response
+CFUN: (list of supported <fun>s),(list of supported <rst>s)
OK
Response
+CFUN: <fun>
OK
Response
OK
If there is any error related to ME functionality:
+CME ERROR: <err>
15s, determined by network.
Minimum functionality
Full functionality (Default)
Disable the ME from both transmitting and receiving RF signals
Do not reset the ME before setting it to <fun> functionality level.
This is the default setting when <rst> is not given.
Reset the ME. The device is fully functional after the reset. This value is available
only for <fun>=1
EC25&EC21 AT Commands Manual
//Switch phone to minimum functionality
//No operator is registered
LTE Module Series
26 / 231