At+Colp Connected Line Identification Presentation - Quectel EC25 Command Manual

Read Command
AT+CLIR?
Write Command
AT+CLIR[=<n>]
Maximum Response Time
Reference
3GPP TS 27.007
Parameter
<n> Parameter sets the adjustment for outgoing calls
0
1
2
<m> Parameter shows the subscriber CLIR service status in the network
0
1
2
3
4

11.6. AT+COLP Connected Line Identification Presentation

The command refers to the GSM/UMTS supplementary service COLP (Connected Line Identification
Presentation) that enables a calling subscriber to get the connected line identity (COL) of the called party
after setting up a mobile originated call. The command enables or disables the presentation of the COL at
the TE. It has no effect on the execution of the supplementary service COLR in the network.
EC25&EC21_AT_Commands_Manual
Response
+CLIR: <n>,<m>
OK
Response
TA restricts or enables the presentation of the calling line
identity (CLI) to the called party when originating a call.
The command overrides the CLIR subscription (default is
restricted or allowed) when temporary mode is provisioned as
a default adjustment for all following outgoing calls. This
adjustment can be revoked by using the opposite command.
OK
If there is any error related to ME functionality:
+CME ERROR: <err>
15s, determined by network.
Presentation indicator is used according to the subscription of the CLIR service
CLIR invocation
CLIR suppression
CLIR not provisioned
CLIR provisioned in permanent mode
Unknown (e.g. no network, etc.)
CLIR temporary mode presentation restricted
CLIR temporary mode presentation allowed
LTE Module Series
EC25&EC21 AT Commands Manual
183 / 231