Quectel EC25 Command Manual page 59

Write command
AT+QINDCFG=<urctype>[,<enable>[,<
savetonvram>]]
Maximum Response Time
Parameter
<urctype>
EC25&EC21_AT_Commands_Manual
OK
Response
If <enable> and <savetonvram> are omitted, the current
configuration will be returned:
+QINDCFG: <urctype>,<enable>
OK
If <enable> and <savetonvram> are not omitted, set the
URC indication configurations:
OK
ERROR
If there is any error related to ME functionality:
+CME ERROR: <err>
300ms
URC type
"all"
"csq"
"smsfull"
"ring"
"smsincoming"
"act"
EC25&EC21 AT Commands Manual
Main switch of all URCs. Default is ON.
Indication of signal strength and channel bit error rate
change (similar to AT+CSQ). Default is OFF. If this
configuration is ON, present:
+QIND: "csq",<rssi>,<ber>
SMS storage full indication. Default is OFF. If this
configuration is ON, present:
+QIND: "smsfull",<storage>
"RING" indication. Default is ON.
Incoming message indication. Default is ON.
Related URCs list:
+CMTI, +CMT, +CDS
Indication of network access technology change.
Default is OFF. If this configuration is ON, present:
+QIND: "act",<actvalue>
<actvalue> is string format. The values are as below:
"GSM"
"EGPRS"
"WCDMA"
"HSDPA"
"HSUPA"
"HSDPA&HSUPA"
LTE Module Series
58 / 231