Ats10 Set Disconnection Delay After Indicating The Absence Of Data Carrier; At+Cbst Select Bearer Service Type - Quectel EC25 Command Manual

7.12. ATS10 Set Disconnection Delay after Indicating the Absence of
Data Carrier
The command determines the amount of time (unit: tenths of a second) during which the UE remains
connected in absence of a data carrier.

ATS10 Set Disconnection Delay after Indicating the Absence of Data Carrier

Read Command
ATS10?
Write Command
ATS10=<n>
Maximum Response Time
Reference
V.25ter
Parameter
<n> 1-15-254

7.13. AT+CBST Select Bearer Service Type

The Write Command selects the bearer service <name>, the data rate <speed> and the connection
element <ce> to be used when data calls are originated.
AT+CBST Select Bearer Service Type
Test Command
AT+CBST=?
Read Command
EC25&EC21_AT_Commands_Manual
Response
<n>
OK
Response
This parameter setting determines the amount of time (unit:
tenths of a second) during which the TA will remain connected
in absence of a data carrier. If the data carrier is once more
detected before disconnection, the TA remains connected.
OK
300ms
Number of tenths of seconds to wait before disconnecting after UE has indicated
the absence of received line signal
Response
+CBST: (list of supported <speed>s),(list of supported
<name>s),(list of supported <ce>s)
OK
Response
LTE Module Series
EC25&EC21 AT Commands Manual
98 / 231