At+Qsclk Enable/Disable Entering Into Sleep Mode - Quectel EC25 Command Manual

0 Fail
1 Success
<value> The voltage of specified ADC channel. Unit is mV.

13.5. AT+QSCLK Enable/Disable Entering into Sleep Mode

The command is used to control whether the module enters into sleep mode. When entering into sleep
mode is enabled, DTR is pulled up and WAKEUP_IN is pulled up, the module can directly enter into sleep
mode. If entering into sleep mode is enabled, DTR is pulled down and WAKEUP_IN is pulled down, there
is a need to pull the DTR pin and the WAKEUP_IN pin up first, and then the module can enter into sleep
mode.
AT+QSCLK Enable/Disable Entering into Sleep Mode
Test Command
AT+QSCLK=?
Read Command
AT+QSCLK?
Write Command
AT+QSCLK=<n>
Maximum Response Time
Reference
Quectel
Parameter
<n> 0
1
EC25&EC21_AT_Commands_Manual
Response
+QSCLK: (list of supported <n>s)
OK
Response
+QSCLK: <n>
OK
Response
OK
300ms
Disable slow clock
Enable slow clock. It is controlled by DTR
LTE Module Series
EC25&EC21 AT Commands Manual
207 / 231