Quectel EC25 Command Manual page 153

Read Command
AT+CGQMIN?
Write Command
AT+CGQMIN=<cid>[,<precedence>[,<
delay>[,<reliability>[,<peak>[,<mean>
]]]]]
Maximum Response Time
Reference
3GPP TS 27.007
Parameter
<cid> A numeric parameter which specifies a particular PDP context definition (see
AT+CGDCONT command)
<PDP_type> Packet Data Protocol type
"IP"
"PPP"
"IPV6"
"IPV4V6"
<precedence> A numeric parameter which specifies the precedence class
0
1
2
3
<delay> A numeric parameter which specifies the delay class. This parameter defines the
end-to-end transfer delay incurred in the transmission of SDUs through the network.
For the detail please refer to Table 5
0
EC25&EC21_AT_Commands_Manual
(list of supported <peak>s),
(list of supported <mean>s)
OK
Response
[+CGQMIN:
<cid>,<precedence>,<delay>,<reliability>,<peak>,<mean
>]
[+CGQMIN:
<cid>,<precedence>,<delay>,<reliability>,<peak>,<mean
>]
[...]
OK
Response
OK
If there is any error related to ME functionality:
+CME ERROR: <err>
300ms
IPV4. Internet Protocol (IETF STD 5)
Network subscribed value
High Priority. Service commitments shall be maintained ahead of precedence
classes 2 and 3
Normal priority. Service commitments shall be maintained ahead of
precedence class 3
Low priority. Service commitments shall be maintained
Network subscribed value
LTE Module Series
EC25&EC21 AT Commands Manual
152 / 231