Quectel EC25 Command Manual page 185

AT+COLP Connected Line Identification Presentation
Test Command
AT+COLP=?
Read Command
AT+COLP?
Write Command
AT+COLP[=<n>]
Maximum Response Time
Reference
3GPP TS 27.007
Parameter
<n> Parameter sets/shows the result code presentation status in the TA
0
1
<m> Parameter shows the subscriber COLP service status in the network
0
1
2
<number> Phone number in string type, format specified by <type>
<type> Type of address octet in integer format
129
145
<subaddr> String type sub-address of format specified by <satype>
<satype> Type of sub-address octet in integer format (refer to 3GPP TS 24.008 subclause
10.5.4.8)
<alpha> Optional string type alphanumeric representation of <number> corresponding to the
entry found in phone book
EC25&EC21_AT_Commands_Manual
Response
+COLP: (list of supported <n>s)
OK
Response
+COLP: <n>,<m>
OK
Response
TA enables or disables the presentation of the COL
(Connected Line) at the TE for a mobile originating a call. It
has no effect on the execution of the supplementary service
COLR in the network.
Intermediate result code is returned from TA to TE before any
+CR or V.25ter responses.
OK
15s, determined by network.
Disable
Enable
COLP not provisioned
COLP provisioned
Unknown (e.g. no network, etc.)
Unknown type (IDSN format number)
International number type (ISDN format )
LTE Module Series
EC25&EC21 AT Commands Manual
184 / 231