Ats0 Set Number Of Rings Before Automatically Answering Call - Quectel EC25 Command Manual

Parameter
<n> 0
NOTE
When TA returns to data mode from command mode successfully, CONNECT <text> is returned. Please
note that <text> outputs only when <value> is greater than 0 in ATX<value> parameter setting.

7.8. ATS0 Set Number of Rings before Automatically Answering Call

The command controls automatic answering mode for the incoming calls.
ATS0 Set Number of Rings before Automatically Answering Call
Read Command
ATS0?
Write Command
ATS0=<n>
Maximum Response Time
Reference
V.25ter
Parameter
<n> 0
1-255
NOTE
If <n> is set too high, the calling party may hang up before the call is answered automatically.
Example
ATS0=3
OK
EC25&EC21_AT_Commands_Manual
Switch from command mode to data mode
Response
<n>
OK
Response
This parameter setting determines the number of rings before
auto-answer.
OK
300ms
Automatic answering is disabled
Enable automatic answering on the ring number specified
EC25&EC21 AT Commands Manual
//Set three rings before automatically answering a call
LTE Module Series
95 / 231