Table of Contents
Advertisement
Table 10: Turn-off Timing of the Module Through FCPO#
Symbol
Min.
T
6.84 s
turn-off
3.5.2. Turn off the Module Through AT Command
It is also a safe way to use AT+QPOWD command to turn off the module. For more details about the
command, see document [4].
The module is designed to be turned on with a host GPIO. Pull down FULL_CARD_POWER_OFF# pin
after the module's USB/PCIe is removed. Otherwise, the module will turn on again.
VCC(H)
RESET#(H)
FCPO#
RFFE_VIO_1V8
USIM_VDD
USB/PCIe
Module Status
NOTES:
1. The host GPIO must pull down FCPO# after the USB/PCIe interface is removed;
2. As shown by the dotted line, it is recommended to disconnect VCC and pull RESET# low after the module shuts down.
Figure 11: Turn-off Timing Through AT Command and FCPO#
Table 11: Turn-off Timing of the Module Through AT Command and FCPO#
Symbol
Min.
T
6.84 s
turn-off
RM502Q-GL_Hardware_Design
Typ.
Max.
-
-
3.7 V
1.8 V
≥ 1.19 V
V
IH
1.8 V
1.8 V or 3.0 V
Running
Typ.
-
Comment
Module system turn-off time.
AT+QPOWD
Turn-off procedure
T
turn-off
Max.
Comment
-
Module system turn-off time
5G Module Series
RM502Q-GL Hardware Design
USB/PCIe removed
OFF
32 / 83
Advertisement
Table of Contents
