Quectel EC25 Command Manual page 160

Write Command
AT+CGEQMIN=[<cid>[,<Traffic class>
[,<Maximum bitrate UL>
[,<Maximum bitrate DL>
[,<Guaranteed bitrate UL>
[,<Guaranteed bitrate DL>
[,<Delivery order>
[,<Maximum SDU size>
[,<SDU error ratio>
[,<Residual bit error ratio>
[,<Delivery of erroneous SDUs>
[,<Transfer delay>
[,<Traffic handling priority>
[,<Source statistics descriptor>
[,<Signalling indication>]]]]]]]]]]]]]]]
Maximum Response Time
Reference
3GPP TS 27.007
Parameter
<cid>
<PDP_type>
EC25&EC21_AT_Commands_Manual
<Residual bit error ratio>,
<Delivery of erroneous SDUs>,
<Transfer delay>,
<Traffic handling priority>,
<Source statistics descriptor>,
<Signalling indication>]
[...]
OK
Response
OK
If there is any error related to ME functionality:
+CME ERROR: <err>
300ms
PDP context identifier. A numeric parameter which specifies a
particular PDP context definition. The parameter is local to the TE-MT
interface and is used in other PDP context-related commands. The
range of permitted values (minimum value=1) is returned by the test
form of the command
Packet data protocol type. A string parameter which specifies the type
of packet data protocol.
"IP" IPV4
"PPP"
"IPV6"
"IPV4V6"
The following parameters are defined in 3GPP TS 23.107
LTE Module Series
EC25&EC21 AT Commands Manual
159 / 231