At+Cgpaddr Show Pdp Address - Quectel EC25 Command Manual

]]]
Maximum Response Time
Reference
3GPP TS 27.007
Parameter
<L2P> A string parameter that indicates the layer 2 protocol to be used between the TE and MT:
PPP (Point to Point protocol) for a PDP such as IP
Other values are not supported and will result in an ERROR response to the execution
command
<cid> A numeric parameter which specifies a particular PDP context definition (see
AT+CGDCONT command)

10.9. AT+CGPADDR Show PDP Address

The Write Command returns a list of PDP addresses for the specified context identifiers. If no <cid> is
specified, the addresses for all defined contexts are returned.
AT+CGPADDR Show PDP Address
Test Command
AT+CGPADDR=?
Write Command
AT+CGPADDR[=<cid>[,<cid>[,...]]]
Maximum Response Time
Reference
3GPP TS 27.007
EC25&EC21_AT_Commands_Manual
ERROR
If there is any error related to ME functionality:
+CME ERROR: <err>
300ms
Response
+CGPADDR: (list of defined <cid>s)
OK
Response
+CGPADDR: <cid>,<PDP_addr>
[+CGPADDR: <cid>,<PDP_addr>[...]]
OK
ERROR
300ms
LTE Module Series
EC25&EC21 AT Commands Manual
164 / 231