At+Cgact Activate Or Deactivate Pdp Context - Quectel UG Series Command Manual

<Signalling Indication>

10.7. AT+CGACT Activate or Deactivate PDP Context

The AT+CGACT write command is used to activate or deactivate the specified PDP context(s). After the
command has been completed, the MT remains in V.250 command state. If any PDP context is already in
the requested state, the state for that context remains unchanged. If the MT is not PS attached when the
activation form of the command is executed, the MT first performs a PS attach and then attempts to
activate the specified contexts. If no <cid> specifies the activation/deactivation form of the command, it
will activate or deactivate all defined contexts.
AT+CGACT Activate or Deactivate PDP Context
Test Command
AT+CGACT=?
Read Command
AT+CGACT?
Write Command
AT+CGACT=<state>,<cid>
Maximum Response Time
Reference
3GPP TS 27.007
Parameter
<state> Indicates the state of PDP context activation
0 Deactivated
1 Activated
WCDMA_UGxx_AT_Commands_Manual
1 Characteristics of SDUs corresponds to a speech source
Integer type, indicates signaling content of submitted SDUs for a PDP
context.
0 PDP context is not optimized for signaling
1 PDP context is optimized for signaling <PDP_type>
Response
+CGACT: (list of supported <state>s)
OK
Response
[+CGACT:<cid>,<state>[<CR><LF>
+CGACT: <cid><state>[...]]]
OK
Response
OK
NO CARRIER
If error is related to ME functionality:
+CME ERROR: <err>
150s, determined by network.
Confidential / Released
UMTS/HSPA Module Series
WCDMA UGxx AT Commands Manual
157 / 247