wtw inoLab Level 3 Operating Manual page 58

System settings
Using an external
temperature probe
Entering the
temperature value
manually
58
4 Select the pH setup menu item with
5 Confirm the pH setup menu item with
6 Select the O2/Cond TP menu item with
7 Confirm the O2/Cond TP menu item with
The temperature measurement is active (✔).
8 Terminate the Menu mode with
y z
or appears on the display so you can check
your setting.
If you want to measure the temperature using an external
temperature probe, proceed as follows:
1 Connect the temperature probe to the measuring
module.
2 Immerse the temperature probe in the test sample.
The measured temperature value is displayed.
If you want to enter the temperature manually instead of
measuring it automatically, proceed as follows:
1 Measure the current temperature of the test sample.
2 Call up the Display mode with
3 Call up the pH measured variable with
82
.
g
.
82
.
g
.
m
.
m
.
46
.