Data output
212
You can start the data output to the integrated printer or the
RS232 interface as follows:
l
Manually
– by pressing the
prints, e.g. the current measured value or the current
calibration protocol
– by pressing the
prints the current measured value
(precondition: the AutoRead function is not active)
– by selecting Print in the menu:
prints, e.g. the system configuration or selected
elements of a data memory
l
Automatically
– by selecting Print in the menu:
prints, e.g. the recording on the digital recorder
– after each AutoRead measurement with a stable
measured value
– each time a measured value is stored if AutoStore is
9
active (
– after each calibration when the calibration record is
output
p
softkey:
g
key on the measuring module:
flashes)