Definitions / Tools; Signals And Parameters (Presentation) - Siemens Desigo RXB Technical Manual

Room unit
ETS3 Professional
Note!
STOP
ACS Service
HandyTool
K NX
CO
R
S-mode
communication objects
(1)
Key
Note
Siemens
Building Technologies
2

Definitions / Tools

2.1

Signals and parameters (presentation)

The inputs, outputs and parameters of an application can be influenced in various
ways. These are identified by the following symbols in this description of functions:
Parameters identified by this symbol are influenced by the room unit.
Parameters identified by this symbol are set using ETS3 Professional (EIB tool
software).
The RXB Konnex controller parameters CANNOT be set with the ETS2 tool.
Parameters identified by this symbol are set with the ACS Service tool.
Parameters identified by this symbol are set with the HandyTool tool.
Inputs and outputs identified by this symbol communicate with other KNX devices.
They are called communication objects (CO).
Graphical symbol for an S mode input communication object.
Graphical symbol for an LTE input communication object.
Graphical symbol for an S mode output communication object.
Graphical symbol for an LTE output communication object.
The communication objects of the RXB Konnex controllers work in part in S mode, in
part in LTE mode and in part in both modes. These objects are described accordingly.
The following table describes each communication object working in S-mode:
Time scheduler Use (Input communication object)
Flags Type
R W C T U
0 1 1 0 0 20.002
DPT_BuildingMode
(1)
Flags:
Type
Send heartbeat
Receive timeout
States or values
A list of all S mode communication objects is located in section 13.5; a detailed
description of the Konnex data types in section 0.
RXB (KNX) application library
Definitions / Tools
Receive timeout
yes
Communication object name
R Read
W Write
C Communication
T Transmit
U Update.
Konnex data type
Yes = Cyclical send
Yes = Cyclical receive (timeout)
Range of states or values which can be adopted
by the send heartbeat communication object
FNC Description of functions for FC-10, FC-11, FC-12
States
0 = In use
1 = Not in use
2 = Protection
11/166
CM110385en_05
28 Feb 2009