Monitor and operate
Exit test mode
Siemens
Building Technologies
2)
T21 and T22 have the same effect in changeover applications.
4)
Only for RXB24.1/CC-02.
6)
If not used by the application.
7)
Operates only the I/Os of the controller in test mode, no bus actuators.
9)
Values are correct when read, but will not automatically be updated.
The positions can be selected with < (Enter).
• The inputs are displayed
• Outputs can be set via < (Enter) and + / –.
To exit test mode, press >- (Escape) 2 - 3 times (depending on the situation).
If no further button is pressed for 5 minutes, the controller automatically reassumes
Normal mode and all physical outputs are switched back.
RXB (KNX) Applications library
Definitions / Tools
CLC and RAD description of functions for CC-02 CM110384en_03
19/140
28 Feb 2009