ST STM32F205 series Reference Manual page 1370

Revision history
Date
02-May-2018
1370/1378
Table 224. Document revision history (continued)
Version
USART
Replaced all occurrences of
– nCTS by CTS
– nRTS by RTS
– SCLK by CK
Removed note related to RXNEIE in
Added note in ONEBIT description in
3 (USART_CR3).
SPI
Register for RXONLY changed from SPI_CR2 to SPI_CR1 in
Section 25.3.4: Configuring the SPI for half-duplex communication
and Section : Unidirectional receive-only procedure (BIDIMODE=0
and RXONLY=1).
USB OTG_FS
Replaced bit 18 by bit 19 in OEPINT bit description of
OTG_FS_DAINT and OEPM bit description of
OTG_FS_DAINTMSK.
Updated reset values for
register (OTG_FS_HPTXFSIZ)
transmit FIFO size register (OTG_FS_DIEPTXFx) (x = 1..3, where x
is the FIFO_number).
8
Updated STALL bit description in
(continued)
register (OTG_FS_DOEPCTLx) (x = 1..3, where x =
Endpoint_number).
USB OTG_HS
Removed I2C interface from the whole document.
Updated Figure 373: USB OTG interface block diagram
Table 159: OTG_HS input/output
Added Figure 374: USB host-only
Modified SOF pulse width in
Added Table 160: Compatibility of STM32 low power modes with the
OTG in Section 30.8: OTG_HS low-power
Updated Figure 377: Interrupt
Updated Table 163: Device-mode control and status
Section : OTG_HS control and status register
(OTG_HS_GOTGCTL): updated reset value and SRQ definition.
Updated Section : OTG_HS USB configuration register
(OTG_HS_GUSBCFG)
Section : OTG_HS reset register
reset value and FCRST definition.
Section : OTG_HS interrupt mask register
changed PRTIM access type to 'rw' and suppressed EPMISM bit.
Updated Section : OTG_HS Receive FIFO size register
(OTG_HS_GRXFSIZ)
RM0033 Rev 8
Changes
Section : Reception using
Section 24.6.6: Control register
OTG_FS Host periodic transmit FIFO size
and OTG_FS device IN endpoint
OTG_FS device endpoint-x control
pins.
connection.
Section 30.7.2: Peripheral
modes.
hierarchy.
(OTG_HS_GRSTCTL): updated
(OTG_HS_GINTMSK):
reset value.
RM0033
DMA.
and added
SOFs.
registers.