ST STM32F205 series Reference Manual page 1359

RM0033
Date
13-Dec-2011
Table 224. Document revision history (continued)
Version
RTC:
Updated Section 22.3.9: RTC coarse digital
Added note to DC[4:0] bit description in
calibration register
I2C:
Updated Note in
(I2C_CCR).
USART:
Updated Section 24.3: USART functional description
IrDA_RDI and IrDA_TDO and removed IRDA_OUT and IRDA_IN
from Figure 223: USART block
Updated Section 24.3.11: Smartcard
configured as open drain.
Section 24.6.6: Control register 3
related to UART5 in DMAT and DMAR description.
SPI:
Modified Section : Slave select (NSS) pin management
related to NSS in
mode.
SDIO:
4
Updated SDIO/DMA interface configuration steps in
(continued)
SDIO APB2
Updated value and description for bits [45:40] and [7:1] in
R4 response. Updated value at bits [45:40] in
response.
USB OTG FS:
Updated INEPTXSA description in
endpoint transmit FIFO size register (OTG_FS_DIEPTXFx) (x = 1..3,
where x is the
Changed PHYSEL from bit 7 to bit 6 of the
configuration register
USB OTG HS:
Updated INEPTXSA description in
endpoint transmit FIFO size register (OTG_HS_DIEPTXFx) (x = 1..7,
where x is the
Added PHYSEL and updated FSLSPCS for LS host mode in
Section : OTG_HS USB configuration register
(OTG_HS_GUSBCFG).
ETHERNET:
Updated standard for precision networked clock synchronization in
Section 28.1: Ethernet introduction
introduction.
RM0033 Rev 8
Changes
(RTC_CALIBR).
2
Section 23.6.8: I C Clock control register
diagram.
(USART_CR3): removed notes
Section 25.3.3: Configuring the SPI in master
interface.
Section : OTG_FS device IN
FIFO_number).
(OTG_FS_GUSBCFG).
Section : OTG_HS device IN
FIFO_number).
and
Revision history
calibration.
Section 22.6.7: RTC
to remove
to specify that TX pin must be
and note
Section 26.3.2:
Table 129:
Table 131: R5
Section : OTG_FS USB
Section 28.1: Ethernet
1359/1378
1372