ST STM32F205 series Reference Manual page 1362

Revision history
Date
05-Nov-2012
1362/1378
Table 224. Document revision history (continued)
Version
TIM1 to TIM8 (continued):
Updated configuration for example of counter operation in encoder
interface mode in
Updated Section 13.3.18: Interfacing with Hall
Changed definition of ARR[15:0] bits in
TIM8 auto-reload register
Updated BKE definition in
and dead-time register
TIM2 to TM5:
Restored TIM2 to TIM5 block diagram.
Updated 16-bit prescaler range in
features.
External clock mode 2 restricted to TIM2 to TIM4 in
Clock selection.
Updated Section 14.3.6: PWM input mode
Clearing the OCxREF signal on an external
Updated Figure 153: Master/Slave timer example
ITR0. Updated
to an external
Section 14.4.3. Restored TIMx internal trigger connection table for
TIM2 to TIM5. Updated TIMx_CCER bit description for TIM2 to TIM5.
5 TIM6 to TIM7:
(continued)
Updated 16-bit prescaler factor in
features. Removed references to repetition counter.
HASH:
Updated Section 21.4.7: HASH context swap registers
(HASH_CSRx)
RNG:
Updated Section 20.1: RNG
RTC:
Updated Section : RTC register write
Updated Section 22.3.8: RTC reference clock
Added system reset value for
status register
Added system reset value in
(RTC_TR),
reset value to system reset value in
register (RTC_CR). Added power-on reset value and changed reset
value to system reset value in
register (RTC_TSTR). Updated definition of ALARMOUTTYPE in
Section 22.6.13: RTC tamper and alternate function configuration
register (RTC_TAFCR). Renamed RTC_BKxR into RTC_BKPxR in
Table 80: RTC register map and reset
RM0033 Rev 8
Changes
Section 13.3.16: Encoder interface
(TIMx_ARR).
Section 13.4.18: TIM1 and TIM8 break
(TIMx_BDTR).
Section 14.2: TIM2 to TIM5 main
Section : Starting 2 timers synchronously in response
trigger. Restored bits 15 to 8 of TIMx_SMCR in
Section 16.2: TIM6 and TIM7 main
introduction.
Section 22.6.4: RTC initialization and
(RTC_ISR).
Section 22.6.1: RTC time register
Section 22.6.2: RTC date register
Section 22.6.11: RTC time stamp time
RM0033
mode.
sensors.
Section 13.4.12: TIM1 and
Section 14.3.3:
and Section 14.3.11:
event.
to change ITR1 to
protection.
detection.
(RTC_DR). Changed
Section 22.6.3: RTC control
values.